Differences

This shows you the differences between two versions of the page.

--- sa48-00 [2017/07/17 17:55] – [Using Integrated Logins] Justin Willey
+++ sa48-00 [2025/07/03 11:37] (current) – [Using a different database or connecting as a different user] Justin Willey
@@ Line 10: / Line 10: @@
 {{ :17-07-2017_18-31-12.png?direct |}}
   * **Domains allowed to connect** list (separated by semicolons) the domains you wish to allow integrated logins from.
-  * **Domain group** The active Directory group that controls access to IQX
+  * **Domain group** The Active Directory group that controls access to IQX
+Users' IQX login names must match their Windows user names.
 ==== To Configure in Active Directory ====
@@ Line 20: / Line 19: @@
 ==== Using Integrated Logins ====
 If integrated logins are enabled (see above), when IQX is launched it checks whether the current Windows user is:
-* a properly authorised member of an authorised domain
+  * a properly authorised member of an authorised domain
-* a proper;y authorised member of the active directory group specified
+  * a properly authorised member of the active directory group specified
-* is a valid, current IQX user defined in IQX user maintenance
+  * is a valid, current IQX user defined in IQX user maintenance
-* the shortcut clicked specifies the required database
+  * the shortcut clicked specifies the required database
 If all these conditions are satisfied, the user is logged in to IQX without the normal login dialog box being displayed. The user is given the user rights and credentials specified in IQX for that Windows user.
@@ Line 31: / Line 30: @@
 After connecting as the current windows user. Choose File | Change User from the IQX menu. The the usual IQX login dialog box is then shown.
+Alternatively, and this is the best method if wanting to force a database update, add the parameter **NoAuto** to the command line when starting IQX. **The parameter is case sensitive and must be the last parameter**. If using a Windows shortcut to launch IQX, the parameter should be added to the command line shown in Target field in the Shortcut tab of the Properties dialog box.